Sub-Zero 500 Information Manual page 11

PRODUCT
CARE
MODEL 590
WA TER DISPENSER
This automatic water and ice dis-
pensing product offers the conve-
nience of dispensing both chilled
water and ice from the product
without having to open the doors.
See Figure 13.
Figure 13
The water dispenser operates
as follows: To operate the water
dispenser, the water dispenser
switch must be depressed
continuously for the required
amount. This switch is located on
the refrigerator door glasswell. See
Figure 13. The very first time the
water dispenser is operated, it will
be necessary to flush and purge
the water system and water
storage tank for three minutes.
This procedure will clear out any
air in the system as well as any
foreign material that occurs with a
new plumbing connection in the
home.
The chilled water container is
mounted inside the refrigerator
section.
It
will take several hours to
chill the water to the refrigerator
temperature upon the original fill or
if a significant amount of water is
used.
IACAUTION
I
Do not run the water dispenser
switch any longer than 8 min-
utes continuously as this will
damage the equipment.
MODEL 590
ICE DISPENSER
The ice dispenser operates as
follows: To operate the ice dis-
penser, the ice dispenser switch
must be depressed continuously
for the required amount. This
switch is located on the refrigerator
door glasswell. See Figure 13.
After original start-up of the ice-
maker operation, it will be neces-
sary to discard the first few batches
of ice as they may be discolored
due to the new plumbing connec·
tion to the home.
The ice dispenser feature can
deliver ice in two different ways:
(1) By inserting a glass into the
glasswell and then depressing the
ice dispenser switch as in Figure
13, ice cubes will automatically
dispense into the glass. (2) If a
larger quantity of ice is required,
open up the refrigerator door, posi-
tion an ice container underneath
the ice dispenser chute and then
depress the button for bulk ice
dispensing. See Figure 14.
IACAUTION
I
Do not run the ice dispenser
switch any longer than
8
min-
utes continuously as this will
damage the equipment.
IACAUTION
I
Do not use a fragile glass as the
ice crescents dropping into the
glass from the ice dispenser
may break this type of glass.
Figure 14
MODEL 590
ICE DISPENSER
OPERATING TIPS
1)
If
no ice, is the ice system
switch on? See Figure 18.
2) Make sure there is a supply of
ice in storage container. See
"Ice Storage Container"
page12.
3) Make sure storage container is
all the way in to insure proper
engagement of auger motor to
back of container. If ice con-
tainer is not all the way back,
push on container and ice
dispenser switch at the same
time to properly engage.
4) Make sure freezer utility rack
is properly installed as this
insures proper ice storage
container positioning. See
"Freezer Utility Rack" page 12.
5) Press ice dispenser switch. If
no auger motor noise is heard,
wait 5 minutes and try again.
On second try if no auger
motor noise is heard, call
your local Factory Authorized
Service Agency.
6) If the ice dispenser is not used
for an extended period, the ice
will tend to fuse together.
It
will
be necessary to discard old
ice.
11