SOMFY Roll Up 28 RTS 447 MHz Instructions Manual

SOMFY Roll Up 28 RTS 447 MHz Instructions Manual

Hide thumbs Also See for Roll Up 28 RTS 447 MHz:
Table of Contents

Advertisement

www.somfy.com
Roll Up 28 RTS 447 MHz
Instructions
EN
KO
사용 설명서

Advertisement

Table of Contents
loading

Summary of Contents for SOMFY Roll Up 28 RTS 447 MHz

  • Page 1 Roll Up 28 RTS 447 MHz Instructions 사용 설명서...
  • Page 2: Table Of Contents

    The Roll Up 28 RTS 447 MHz can motorize roller blinds, silhouette blinds, and zebra blinds. The Roll Up 28 RTS 447 MHz is a 12VDC operated motor, powered by a power supply. Warning : The Roll Up 28 RTS 447 MHz cannot be used with sealed double glazing.
  • Page 3: Liability

    Safety instructions document, after installing the drive. Any After-Sales Service operation on the drive must be performed by a motorisation and home automa- tion professional. If in doubt when installing the drive, or to obtain additional information, contact a Somfy adviser or go to the website www.somfy.com. ...
  • Page 4: Installation

    2.1.4. Mounting the motorized tube on the brackets 1) Standard bracket 2) Motor plate for specific bracket For optimal radio reception, the motor antenna should be kept straight and should be positioned outside of headrail (if used). Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 5: Wiring

    Press the RTS transmitter MY button until the shade jogs: the rotation direction has been modified. b2) Press the RTS transmitter UP button to check the rotation direction. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 6 2.3.5. Favorite position: MY position / Recording MY position If desired, to set the MY position, move the shade to the desired position with the UP or DOWN button then press the MY button until the shade jogs. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 7: Use And Maintenance

    UP or DOWN button. 2) To stop the shade, press the MY button. 3) If a MY position is recorded,To move the shade to this MY position, press briefly the MY button. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 8: Up, Down, My: In Tilting Mode

    The shade first goes to the down end limit, then to the MY position. 4) To tilt the slats, press and hold the UP or DOWN button until the slats reach the desired position. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 9: Additional Settings

    3) Press and hold the UP or DOWN button to move the shade to the new desired position. 4) To confirm the new limit press and hold the MY button until the shade jogs. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 10 PROG button until the shade jogs: the motor is in programming mode. Quickly press the RTS transmitter(B) PROG button to add or delete: the shade jogs and the PROG. PROG. RTS transmitter is programmed or deleted from the motor. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 11: Tips And Recommendations

    The equipment stops too soon: Verify: • The operation of end-limits during the motor rotation. • The end-limits of the motor are properly adjusted. • That the shade is within the recommended weight limit. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 12: Technical Data

    Operating temperature 0°C to + 60°C Protection rating IP 20 (For indoor use only) Maximum number of associated control For additional information on the technical data for this drive contact your Somfy representative. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 13: 필수 정보

    4. 기술 사양 2.3. 기본설정 Roll Up 28 RTS 447 MHz는 실내 전용 모터입니다. Roll Up 28 RTS 447 MHz는 롤 블라인드, 실루엣 블라인드 및 콤비 블라인드의 작동 에 사용할 수 있습니다. Roll Up 28 RTS 447 MHz는 전원 공급 장치를 통해 전원을 공급받는 12VDC 모터입 니다. 경고: Roll Up 28 RTS 447 MHz를 밀폐된 이중 유리에 사용할 수 없습니다. 1. 필수 정보 1.1 용도...
  • Page 14: 책임

    모터를 설 치 및 사 용하기 전 에 본 설 명서를 읽 고 숙 지하십시오. 본 설 명서의 지 침 외 에 첨 부된 안전 지침의 지시사항도 반드시 준수하십시오. 모터는 Somfy가 제공하는 지침과 사용 국가의 관련 법규에 따라 모터 및 홈 오토메이션 설치 기사가 설치해야 합니다.
  • Page 15: 설치

    샤프트를 원하는 길이만큼 절단하십시오. 샤프트에서 금속 찌꺼기를 제거하십시오. 2.1.3. 모터/샤프트 조립 1) 모터를 샤프트로 밀어 넣으십시오. 휠을 샤프트 모양에 맞춰 끼우십시오. 모터를 절반 정도 끼운 다음 크라운을 모터 끝으로 밀어 넣고 샤프트에 끼우십시오. 마지막으로 모터를 샤프트로 밀어 넣으십시오. 2) 필수사항은 아니지만, 필요 시 치수 (L)에 따라 셀프 태핑 나사나 스틸 팝 리벳으로 사프트를 모터에 고정하십시오. 2.1.4. 모터/샤프트를 브라켓에 장착 1) 표준 브라켓 2) 브라켓별 모터 플레이트 최상의 무선 수신을 위해서는 모터 안테나를 곧은 상태로 유지해야 하고, 헤드레일 사용 시 헤드레일 밖에 두어야 합니다. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 16: 배선

    쉐이드가 내려가면(b), 회전 방향이 올바르지 않은 것입니다. 다음 단계로 가십시오. b1) 쉐이드가 짧게 왕복할 때까지 RTS 송신기의 MY 버튼을 누르십시오. 회전 방향이 변경 됩니다. b2) RTS 송신기의 상 버튼을 눌러 회전 방향을 확인하십시오. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 17 누르십시오. 쉐이드가 짧게 왕복합니다. 송신기가 설정됩니다. PROG. 2.3.5. 선호 위치: MY 위치 / MY 위치 설정 MY 위치를 설정하려면, 상 또는 하 버튼을 사용해 쉐이드를 원하는 위치로 이동한 다음, 쉐이드가 짧게 왕복할 때까지 MY 버튼을 누르십시오. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 18: 사용 및 유지보수

    1) 쉐이드를 한 리미트에서 다른 리미트로 이동하려면, 상 또는 하 버튼을 짧게 누르십시오. 2) 쉐이드를 멈추려면, MY 버튼을 누르십시오. 3) MY 위치가 설정된 경우, 쉐이드를 MY 위치로 이동하려면 MY 버튼을 짧게 누르십시오. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 19: 올리기, 내리기, My: 틸팅 모드

    3) MY 위치가 설정된 경우, 쉐이드를 MY 위치로 이동하려면 MY 버튼을 짧게 누르십시오. 쉐이드가 먼저 하단 리미트로 이동한 다음, MY 위치로 이동합니다. 4) 슬랫을 기울이려면, 슬랫이 원하는 위치에 도달할 때까지 상 또는 하 버튼을 길게 누르십시오. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 20: 추가 설정

    2) 쉐이드가 짧게 왕복할 때까지 상/하 버튼을 동시에 길게 누르십시오. 3) 상 또는 하 버튼을 길게 눌러 쉐이드를 원하는 새로운 위치까지 이동하십시오. 4) 새로운 상단/하단 리미트를 확정하려면, 쉐이드가 짧게 왕복할 때까지 MY 버튼을 길게 누르십시오. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 21 송신기 (A) 프로그램 버튼이나 모터 프로그램 버튼을 길게 누르십시오. 모터가 프로그래밍 모드로 진입합니다. 추가 또는 삭제하려면 RTS 송신기 (B) PROG. PROG. 프로그램 버튼을 짧게 누르십시오. 쉐이드가 짧게 왕복하고, RTS 송신기가 추가되거나 모터에서 삭제됩니다. Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 22: 팁 및 권장사항

    • 열 발생(모터가 식을 때까지 기다림) 모터가 너무 일찍 멈춥니다. 점검사항: • 모터 회전 중 상단/하단 리미트 작동 상태 • 상단/하단 리미트가 제대로 조정되었는지 여부 • 쉐이드가 권장 무게 범위를 벗어나지 않는지 여부 Copyright © 2016 Somfy SAS. All rights reserved.
  • Page 23: 기술 사양

    상/하단 리미트 간 최대 거리 6분 최대 작동 시간 0°C ~ + 60°C 작동 온도 IP 20 (실내 전용) 보호 등급 최대 제어 수 이 모터의 기술 데이터에 관한 추가 정보는 Somfy로 문의하시기 바랍니다. 이 기기는 가정용(B급) 전자파적합기기로서 주로 가정에서 사용하는 것을 목적으로 하며, 모든 지역에서 사용 할 수 있습니다 1. 인증번호: MSIP-RMI-SFY-SOMFY-R281-RTS 2. 인증받은 자의 상호: (주)솜피 3. 기자재명칭: 전동형 롤스크린 4. 모델명: SOMFY-R281-RTS 5. 제조사/제조국: Nigbo Dooya Mechanic & Electronic Technology Co., Ltd. / 중국...
  • Page 24 Somfy SAS 50 avenue du Nouveau Monde F - 74300 CLUSES www.somfy.com...

Table of Contents