Jeep Grand Cherokee Operating Information Manual page 89

be adjusted so that the top of the head restraint
is located above the top of your ear.
WARNING!
The head restraints for all occupants must be
properly adjusted prior to operating the ve-
hicle or occupying a seat. Head restraints
should never be adjusted while the vehicle is
in motion. Driving a vehicle with the head
restraints improperly adjusted or removed
could cause serious injury or death in the
event of a collision.
Supplemental Active Head Restraints —
Front Seats
Active Head Restraints are passive, deployable
components, and vehicles with this equipment
cannot be readily identified by any markings,
only through visual inspection of the head re-
straint. The Active Head Restraints (AHR) will
be split in two halves, with the front half being
soft foam and trim, the back half being decora-
tive plastic.
When AHRs deploy during a rear impact, the
front half of the head restraint extends forward
to reduce the gap between the back of the
occupant's head and the AHR. This system is
design to reduce the risk of injury to the driver or
front passenger in certain types of rear impacts.
Refer to "Occupant Restraints" in "Things To
Know Before Starting Your Vehicle" for further
information.
To raise the head restraint, pull upward on the
head restraint. To lower the head restraint, push
the adjustment button, located at the base of
the head restraint, and push downward on the
head restraint.
Adjustment Button
For comfort the Active Head Restraints can be
tilted forward and rearward. To tilt the head
restraint closer to the back of your head, pull
forward on the bottom of the head restraint.
Push rearward on the bottom of the head re-
straint to move the head restraint away from
your head.
Active Head Restraint (Normal Position)
85