Adding Washer Fluid - Jeep Grand Cherokee Operating Information Manual

Rear Wiper Blade Removal/Installation
1. Lift the pivot cap on the rear wiper arm
upward, this will allow the rear wiper blade to
be raised off of the liftgate glass.
Lifting The Pivot Cap
1 — Wiper Arm
2 — Pivot Cap
NOTE:
The rear wiper arm cannot be raised fully
upward unless the pivot cap is raised first.
2. Lift the rear wiper arm upward to raise the
wiper blade off of the liftgate glass.
390
3. Grab the bottom of the wiper blade and
rotate it forward to unsnap the blade pivot
pin from the wiper blade holder.
Removing The Wiper Blade
1 — Wiper Blade
2 — Blade Pivot Pin
3 — Wiper Arm
4 — Wiper Blade Holder
4. Install the wiper blade pivot pin into the wiper
blade holder at the end of the wiper arm, and
firmly press the wiper blade until it snaps into
place.
5. Lower the wiper blade and snap the pivot
cap into place.

Adding Washer Fluid

This vehicle is equipped with a Driver Informa-
tion Display (DID), the DID will indicate when
the washer fluid level is low. When the sensor
detects a low fluid level, the windshield will light
on the vehicle graphic outline and the
"WASHER FLUID LOW" message will be dis-
played.
The fluid reservoir for the windshield washers
and the rear window washer is shared. The fluid
reservoir is located in the engine compartment,
be sure to check the fluid level at regular
intervals. Fill the reservoir with windshield
washer solvent only (not radiator antifreeze).
When refilling the washer fluid reservoir, take
some washer fluid and apply it to a cloth or
towel and wipe clean the wiper blades, this will
help blade performance. To prevent freeze-up
of your windshield washer system in cold
weather, select a solution or mixture that meets
or exceeds the temperature range of your cli-