Keyless Enter-N-Go; Normal Starting - Jeep Grand Cherokee Operating Information Manual

Keyless Enter-N-Go

This feature allows the
driver to operate the ig-
nition switch with the
push of a button, as long
as the Remote Start/
Keyless
Key Fob is in the pas-
senger compartment.
Keyless Enter-N-Go Functions — With
Driver's Foot OFF The Brake Pedal/Clutch
Pedal (In PARK Or NEUTRAL Position)
The Keyless Enter-N-Go feature operates simi-
lar to an ignition switch. It has three positions,
OFF, ACC and RUN. To change the ignition
switch positions without starting the vehicle and
use the accessories, follow these steps starting
with the ignition switch in the OFF position:
1. Push the ENGINE START/STOP button
once to change the ignition switch to the
ACC position,
2. Push the ENGINE START/STOP button a
second time to change the ignition switch to
the RUN position,
3. Push the ENGINE START/STOP button a
third time to return the ignition switch to the
OFF position.
Enter-N-Go

Normal Starting

To Turn On The Engine Using The ENGINE
START/STOP Button
1. The transmission must be in PARK or NEU-
TRAL.
2. Press and hold the brake pedal while push-
ing the ENGINE START/STOP button once.
3. The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the
starter will disengage automatically after 10
seconds.
4. If you wish to stop the cranking of the engine
prior to the engine starting, push the button
again.
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or
pressing the accelerator pedal.
To Turn Off The Engine Using ENGINE
START/STOP Button
1. Place the gear selector in PARK, then push
and release the ENGINE START/STOP but-
ton.
2. The ignition switch will return to the OFF
position.
3. If the gear selector is not in PARK, the
ENGINE START/STOP button must be held
for two seconds or three short pushes in a
row with the vehicle speed above 5 mph
(8 km/h) before the engine will shut off. The
ignition switch position will remain in the
ACC position until the gear selector is in
PARK and the button is pushed twice to the
OFF position. If the gear selector is not in
PARK and the ENGINE START/STOP but-
ton is pushed once, the DID will display a
"Vehicle Not In Park" message and the en-
251