Jeep Grand Cherokee Operating Information Manual page 347

1. Bring the vehicle to a complete stop, with the
engine running.
2. Press and hold the brake pedal.
3. Shift the transmission into NEUTRAL.
4. If vehicle is equipped with Quadra-Lift air
suspension, ensure the vehicle is set to
Normal Ride Height.
5. Using a ballpoint pen or similar object, press
and hold the recessed transfer case NEU-
TRAL (N) button (located by the selector
switch) for four seconds. The light behind the
N symbol will blink, indicating shift in prog-
ress. The light will stop blinking (stay on
solid) when the shift to NEUTRAL (N) is
complete. A "FOUR WHEEL DRIVE SYS-
TEM IN NEUTRAL" message will appear in
the Driver Information Display (DID). Refer
to "Driver Information Display (DID)" in "Un-
derstanding Your Instrument Panel" for fur-
ther information.
NEUTRAL (N) Switch
6. After the shift is completed and the NEU-
TRAL (N) light stays on, release the NEU-
TRAL (N) button.
7. Shift the transmission into REVERSE.
8. Release the brake pedal for five seconds
and ensure that there is no vehicle move-
ment.
9. Press and hold the brake pedal. Shift the
transmission back into NEUTRAL.
10. Firmly apply the parking brake.
11. With the transmission and transfer case in
NEUTRAL, press and hold the ENGINE
START/STOP button until the engine turns
off.
12. Move the transmission gear selector to
PARK. Release the brake pedal.
13. Press the ENGINE STOP/START button
again (without pressing the brake pedal), if
needed, to turn the ignition to the OFF
mode.
14. Attach the vehicle to the tow vehicle using a
suitable tow bar.
15. Turn the ignition to the ON/RUN mode, but
do not start the engine.
16. Release the parking brake.
17. Confirm that the steering column is un-
locked.
18. Disconnect the negative battery cable, and
secure it away from the negative battery
post.
343