Jeep Grand Cherokee Operating Information Manual page 358

Front Jacking Location
5. For a rear tire, place the jack in the slot on
the rear tie-down bracket, just forward of the
rear tire (as indicated by the triangular lift
point symbol on the sill molding). Do not
raise the vehicle until you are sure the
jack is fully engaged.
354
CAUTION!
Do NOT raise the vehicle by the body side
sill molding. Be sure the jack is placed in the
proper engagement location on the inside of
the panel. Damage of the vehicle may occur
if the procedure is not properly followed.
Lift Point Symbol On Sill Molding
Rear Jacking Location
6. Raise the vehicle by turning the jack screw
clockwise. Raise the vehicle only until the
tire just clears the surface and enough clear-
ance is obtained to install the spare tire.
Minimum tire lift provides maximum stability.
WARNING!
Raising the vehicle higher than necessary
can make the vehicle less stable. It could slip
off the jack and hurt someone near it. Raise
the vehicle only enough to remove the tire.