Advertisement
M O D E L 4 3 0
I N S TA L L A T I O N I N S T R U C T I O N S
A N C H O R
T H E U N I T
After door and side panels have been installed,
the unit has been leveled and door adjustment
completed, anchor the unit to the opening.
This will assure a proper fit and a secure
installation. The Sub-Zero Anchoring Kit (part
#4200900), available from your Sub-Zero
dealer, includes the necessary hardware.
IMPORTANT NOTE: Be sure to level and
square the unit before anchoring it.
T W O U N I T S A N C H O R E D T O G E T H E R
13
Drill three
/
" holes through the middle
64
trim of both units.
Using the Loctite on the screws, install the
three Chicago screw posts.
Recheck the units for level.
3
Drill three
/
" holes through both outer
16
trims. Refer to illustration 15 below.
1
Using a
/
" drill bit, drill into the cabinetry
8
for a pilot hole.
Install all six Sems to the cabinetry.
Illus. 15
U N I T A N C H O R E D T O C A B I N E T R Y
First, make sure units have been leveled
and aligned, and doors adjusted.
Drill three
trims. Refer to illustration 16 below.
Drill a
Install all six Sems.
Do not drill through the model and serial
number plate.
Illus. 16
3
/
" holes through both outer
16
1
/
" pilot hole into the cabinetry.
8
M O D E L
4 3 0
O P T I O N A L
C O M P O N E N T S
Optional installa-
tion components
are available
through your
Sub-Zero dealer,
or call Sub-Zero at
800-222-7820.
You can also visit
our website at
subzero.com.
33
Advertisement
