Advertisement
M O D E L S 4 2 7
M O D E L S
S TA I N L E S S S T E E L
4 2 7 | 4 2 7 R
Before installing the stainless steel door panel,
check the panel carefully. Options are available
for kickplate / grille height, overall height, door
swing and door lock.
The stainless steel panel is mounted to the
P A N E L
door by passing the #8–32 x
D E S I G N
provided, through holes in the door frame
from the rear, and into the threaded holes in
Additional panel
the door panel. Refer to illustration 10 below.
design information
The screw holes inside the door are hidden
can be found in
under a cover flap on the door gasket. It is
the Sub-Zero
necessary to lift the flap to insert the screws.
Design Guide.
Check our website
After the door panel installation is complete,
at subzero.com.
apply the cover patches or plugs provided over
the holes on the inside surface of the door.
For installation of stainless steel panels on
Model 427R drawers, see Model 427R Drawer
Panels on page 22.
20
A N D
4 2 7 R
D O O R P A N E L
The cover patches or plugs are part of the
insulation system on the door of the Wine
Storage unit. Be sure to cover all the
holes in the door that were used.
Stainless
Door
Steel
Frame
Panel
Stainless Steel
Panel
Illus. 10
I N S T A L L A T I O N
5
/
" screws
8
Integrated
Panel
Back of
Illus. 11
OV E R L AY G L A S S
D O O R P A N E L
Inspect the door panel for the minimum
(16) thickness, the greater width requirements
for the stiles (to cover the door hinges), and
the finished inside edge. The door panel has a
weight limit of 20 lbs (9 kg). See the Wine
Storage section of the Sub-Zero Design Guide
for additional panel information.
Decide if the handle will be attached through
the glass door frame or just through the deco-
rative door panel. If it is just through the door
panel, the handle must be attached first.
If a lock is to be used, the body of the lock
should be installed on the door panel after the
panel is mounted.
Decorative panels are attached to the Model
427 and 427R door using #8 x
screws passing through the door frame from
the rear, behind the gasket into the panel. The
door panel is marked for screw locations by
the use of 'tenon centers', which are temporar-
1
ily inserted into the
/
" (6) diameter holes in
4
the front of the glass door frame. Refer to
illustration 11 below.
Gasket
Door
Frame
Illus. 12
Tenon Center
5
/
"
8
5
/
" square drive
8
13
/
"
32
(11)
Diameter
Glass
1
/
"
4
(6)
Diameter
Advertisement
