Advertisement
M O D E L 4 3 0
M O D E L
4 3 0
H I N G E
IMPORTANT NOTE: The unit must be installed
and leveled before adjusting the door hinges.
Check to make sure the door is properly
adjusted. If not, adjust the top or bottom door
hinge by first removing and discarding the two
O P T I O N A L
small shipping screws. Refer to illustration 17
C O M P O N E N T S
below. Adjust the top hinge left to right and in
or out by loosening the three allen head
Optional installa-
screws. Adjust the bottom hinge by loosening
tion components
the four allen head screws with a
are available
wrench. Refer to illustration 18. The door will
through your
now be able to move left to right or in and out.
Sub-Zero dealer,
or call Sub-Zero at
800-222-7820.
9 0 - D E G R E E
You can also visit
our website at
subzero.com.
An optional 90-degree door stop kit for Model
430 is available through your Sub-Zero dealer.
C O M P L E T I N G
IMPORTANT NOTE: When you have
completed the installation of the Model 430
Wine Storage unit, refer to the following
Installation Checklist and Service Information.
Dimensions in parentheses are in
34
millimeters unless otherwise specified.
I N S TA L L A T I O N I N S T R U C T I O N S
A D J U S T M E N T
1
D O O R S TO P
T H E I N S TA L L A T I O N
I N S TA L L AT I O N
The importance of the installation of the
Sub-Zero Wine Storage unit cannot be
overemphasized. Proper installation is the
responsibility of the selling dealer or installer.
IMPORTANT NOTE: To ensure a safe and
proper installation, the following checklist
should be completed by the installer to ensure
that no part of the installation has been over-
looked.
/
" (3) allen
8
Any questions or problems regarding the
installation should be directed to your
Sub-Zero dealer or the Sub-Zero Customer
Service Department at 800-222-7820. You may
also check the Contact & Support section of
our website, subzero.com.
Illus. 17
C H E C K L I S T
Illus. 18
Advertisement
