Advertisement
OT H E R F U N C T I O N S :
A U TO M AT I C T U R N O F F
After 4 hours of continuous working from the last function selection, the appliance turns off and
closes automatically.
G R E A S E F I LT E R S S AT U R AT I O N
After 30 hours of working, the speed indicators "D" will all flash simultaneously, signalling the
grease filters saturation.
To reset this alarm, hold down the "TIMER"button for at least 3 seconds, while the carriage is
open.
C A L I B R AT I O N
The cooker hood carries out its self calibration every 3 complete cycles of its extractable unit.
By pushing the "TIMER" key 6 times consecutively (MAX break between one push and the other
is 3 sec.) all the LED's will flash and the calibration will be reset.
After the next 3 cycles the downdraft will carry out its self calibration.
S TA N D - B Y
When the extractable unit is closed and the light is switched off, the control panel, after 6 seconds,
activates the stand-by function, reducing the brightness of the LED's.
This function can be stopped by pressing ON/ OFF or LIGHT key.
S E C U R I T Y S A F T E Y S YS T E M :
If there is an obstacle while the extractable unit is closing, the Downdraft stops closing and rises
again thanks to a security system.
W A R N I N G
This operation has to be carried out by a specialised technician.
14
Instruction manual DD911BK
Please keep this instruction manual for future reference
T I M I N G
As a result of the new EU65 "Energy label"and EU66 " Ecodesign" regulations issued by the
European Commission, which came into force as from January 1st, 2015 , our products have
been adapted to comply with these new requirements. All of the models complying with the
energy label requirements, are equipped with new electronics including a timer device for suction
speed control, when the air capacity exceeds 650m³/h. Internal motor models, with maximum
air capacity higher than 650m³/h, are equipped with a timer device that automatically switches
the suction speed from 4th to 3rd speed, after 6 minutes operation. External motor models are
equipped with remote motors that as with internal motor versions, include a timer device that
switches down the suction speed when it exceeds 650m³/h. (See External Motors Instructions)
Remote motors, whose air capacity exceeds 650m³/h at both 4th and 3rd speed, will have the
following by default timer control functions: The suction speed is automatically switched from
4th to 2nd speed, after 6 minutes operation. If the appliance is working at 3rd speed, it is
automatically switched to 2nd speed after 7 minutes operation. Operation speeds can also be
changed during operation. The energy consumption of the appliance in standby mode is lower
than 0.5W.
Please keep this instruction manual for future reference
15
Instruction manual DD911BK
Advertisement
