Thermoplan BLACK&WHITE ONE BWone-CTM-RF Operator's Manual page 6

Safety instructions
6
General instructions for use
Installation / Transport / Deinstallation
- The machine must only be set up and installed, relocated to another location or re-
moved by authorized and trained service partners of Thermoplan. Be aware and ad-
here to national weight lifting requirements.
- The machine must only be installed using the supplied connection cables and hoses.
Any existing cables or hoses must not be reused. The manufacturer is not liable for
any damages arising from improper installation. The use of incorrect connections
voids the warranty!
- The water connection must only be connected to a drinking water supply system. Be
aware of national requirements for installations to a drinking water supply system.
Check water connections for leaks periodically.
- The voltage quoted on the rating plate must be the same as the mains voltage in your
country.
Use of the BWone-CTM-RF
The BWone-CTM-RF is only suitable for producing coffee, milk and hot water prod-
ucts and is suitable for commercial use in the catering trade. Therefore, please take
note of the following instructions:
- The bean hopper must only be filled with coffee beans. Never fill the bean hopper
with any type of liquid - risk of short circuit! Do not put any ground coffee into the
grinders, as they may become blocked.
- The milk container must only be used to store cold milk. Do not fill the milk container
with any liquids other than milk (e.g. syrup or alcohol). Please note that when pour-
ing the milk into the milk container it must have a temperature of below 5 °C, as the
container has been designed to keep the milk cool but not to lower its temperature.
- Carry out all necessary maintenance work as described in these instructions at regular
intervals.
Cleaning the machine
Cleaning the machine on a daily basis is not only an absolute must, but it also guar-
antees the necessary hygiene and neutral taste as well as a longer life of the machine.
When touching the coffee machine, in particular the spouts, bacterial contamination
must be avoided.
Plastic parts must not be dried in the microwave. For reasons of hygiene, the
machine must be cleaned before it is started up. There are two types of cleaning:
External cleaning:
- Remember to regularly inspect and, if necessary, clean the exterior of the machine.
Please see page 22 for further informations.
- Cloths or sponges must be wrung out thoroughly to ensure that they are only
moist, not wet, otherwise there is a risk of electric shock.
- The machine must not be cleaned with water jets.
Automatic cleaning of the internal components:
The automatic cleaning process with the Thermoplan coffee and milk cleaning tablets
must be run daily as described in the "Daily cleaning" chapter (see page 19). Use only
the Thermoplan coffee and milk cleaning tablets for this purpose.