Gira DALI Gateway Product Documentation page 71

Time delays
Up to two time functions can be independently set for each DALI group. The time functions act solely
on the "Switching" or "Switching central function" communication objects (if a central has been
activated for the affected output) and will delay the received object value as a function of telegram
polarity (cf. fig. 21).
Object
"Disable" / "Forced-control"
*
Staircase timer
Object
function
"staircase timer
(timing)
function start/stop"
*
Object Polarity of
central object
"Central function"
Object
Time functions
"Switching"
Object
"Dimming"
Object
"Brightness value"
*
Scene
Object
control
"Extension unit"
Object
"Brightness value
feedback"
Verzögerung nach
Busspannungswiederkehr
Object
"Switching
feedback"
Activating an ON-delay
The On-delay can be parameterized separately for each group in the plug-in of the DALI Gateway.
Set the "Selection of time delay" parameter in the "Groups - [x] group name – Switch-on/switch-off
behaviour" parameter node to "ON-delay" or to "ON-delay and OFF-delay". Parameterize the desired
On-delay time.
The ON-delay is now enabled. The parameterized time will start after receiving an ON telegram via
the "Switching" object. A subsequent ON-telegram will retrigger the time only if the "ON-delay
retriggerable ?" parameter has been set to "Yes". An OFF-telegram received during the ON-delay will
terminate the delay and set the switching status to "OFF".
Best. Nr. 1060 00
"DALI Gateway C00CX2 EN / C00CX4 EN" software
*
*
*
Soft-ON / OFF
automatic
Dimming speed /
shutoff function
Dimming behaviour
recall
*
storing **
* *
zyklisches Senden
Fig.21: Functional diagram of the time delays
Behaviour
*
- bus voltage failure
additional function
- bus voltage return
- ETS programming
lower higher
Scene priority
*
Functional description
*
Group
Blinking
* = optional parameterization
** = Basically, no new scene value will
be stored if a disable or forced-control
position is active!
Page 71 of 136