Table of Contents
Advertisement
Manual control
Manual control in case of
bus voltage failure
Manual control during
bus mode
Disable function for
manual control ?
Polarity of disable object
for manual control
Transmit manual control
status ?
Best. Nr. 1060 00
"DALI Gateway C00CX2 EN / C00CX4 EN" software
Disabled
Enabled
Disabled
Enabled
Yes
No
0 = enabled / 1 = disabled
1 = enabled / 0 = disabled
Yes
No
In case of a bus voltage failure (bus voltage
switched off) you can determine whether
manual control is to be enabled or
disabled.
For the bus mode (bus voltage switched
on) you can determine whether manual
control is to be enabled or disabled.
The manual control can be disabled via the
bus even with the manual control mode
activated. For this purpose the disable
object can be enabled at this point.
This parameter determines the polarity of
the disable object.
Visible only in case of enabled disable
function for manual control.
After a bus/ mains voltage return or after
programming with the ETS, the disable
function will be immediately active
(object value "0") in case of the setting:
"1 = enabled / 0 = disabled".
The current status of the manual control
can be transmitted to the bus via a
separate status object if bus voltage is
active (setting: "yes").
Parameters
Page 112 of 136
Advertisement
Table of Contents
