Texas Instruments UCD3138PSFBEVM-027 User Manual page 47

www.ti.com
13.1.3 USB-to-GPIO Adaptor Connection
Turn off the DC power source before connecting the USB-to-GPIO adaptor to
avoid electrical shock.
Connect one end of the ribbon cable to the module, and connect the other end to the USB-to-GPIO
(HPA172) interface adapter. Connect the mini connector of the USB cable to the USB interface adapter.
Then connect the other end to the USB port on the host computer, as shown in
13.1.4 Launch the Designer GUI
Click the quick-launch shortcut icon located in the taskbar next to the start menu. When launched, the GUI
searches for a device attached to the PMBus. If the attached device is found and communication between
the GUI and device is successful, a similar-looking screen as shown in
sections describes how to evaluate the module using the GUI.
SLUUAK4 – August 2013
Submit Documentation Feedback
CAUTION
Figure 44. Designer GUI Overview
Copyright © 2013, Texas Instruments Incorporated
Evaluating the EVM with GUI
Figure 41.
Figure 44 is seen. The following
Using the UCD3138PSFBEVM-027
47