Bug Fixes - Solid State Logic C100 HDS Software Update Manual

C100 HDS Software Update

Bug Fixes

The following is a list of the major bugs fixed or resolved in this release:
• PGM bus OLED meters above the faders are now pre-processing
• File synchronization and project integrity have been made more robust
• The HDS logo now appears on boot
• Occassional surface freeze has been fixed
• Morse routing is correctly retained when switching between main and redundant processors
• The mic gain – on a MORSE stagebox connected directly to the processor – displays it's value correctly
• The channel gate no longer fully attenuates when the gate is switched in
• GPIO naming on systems with 2 RIOs now displays correctly
• Morse static output routes are no longer overwritten when switching between main and redundant processors
• The swap function now includes the channel input in the swap. Previously a copy was actioned
• When pressing attention keys to select ASGs or Auxes in the routing menu the attention keys now light
• The processor will now boot correctly if the the ethernet connection to the DAW is not present
• The change over switch now requires a press and hold to action changeover
• In the event of a main processor crash the changeover to the redundant system is actioned faster
• In the event of a dormant processor crash the changeover button on a console surface does not remain lit
• Fader starts on stereo channels are now saved in Control Linking
• Now responds to Morse router restart messages and re-sends mic gain, pad etc
• Added support for Morse router card changeover when ethernet to the active Morse controller card fails
• Clear warning about Morse router being offline from the status bar when its comes back online
• UOP TFT source names now correct respect whether Main or Alt input route is active
• Project Write Protect menu is now always visible when entering the Status Page
• Channel delays no longer introduce delay when dialled in but switched out
• Changeover switch now more reliable
• Routes which go over the 512 total IO slot limit are now permanently greyed out
• A potential system hang no longer possible when locking a channel to the surface
Page 8