Chapter 12 Specifications; General Specifications; Devicenet Specifications - FujiFilm OPC-G1-DEV Manual

Table of Contents

Advertisement

Chapter 12 SPECIFICATIONS

12.1 General Specifications

Install the inverter equipped with the communications card in an environment that satisfies the requirements
listed below.
Item
Site location
Surrounding temperature
Relative humidity
Atmosphere
Altitude
Atmospheric pressure
Vibration
(Note) Do not install the inverter in an environment where it may be exposed to lint, cotton waste or moist dust or dirt
which will clog the heat sink of the inverter. If the inverter is to be used in such an environment, install it in a
dustproof panel of your system.

12.2 DeviceNet Specifications

Item
Network input voltage
Network power consumption
No. of nodes connected
MAC ID
Insulation
Transmission rate
Maximum cable length
(Trunk line: thick cable
Drop line: thin cable)
Messages supported
Vendor ID
Device type
Product code
Model name
Applicable device profile
No. of input/output bytes
Applicable DeviceNet
Specifications
Node type
Indoors
Refer to the FRENIC-MEGA Instruction Manual, Chapter 2.
5 to 95% (No condensation)
The inverter must not be exposed to dust, direct sunlight, corrosive gases,
flammable gases, oil mist, vapor or water drops.
Pollution degree 2 (IEC60664-1)
The atmosphere can contain a small amount of salt.
(0.01 mg/cm
or less per year)
2
The inverter must not be subjected to sudden changes in temperature that will
cause condensation to form.
1,000 m max.
86 to 106 kPa
Refer to the FRENIC-MEGA Instruction Manual, Chapter 2.
11 to 25 V
75 mA at maximum (24 VDC)
(Note) The network power is supplied by an external power source.
64 at maximum (including the master)
0 to 63
500 VDC (photocoupler insulation)
500 kbps/250 kbps/125 kbps
Transmission rate
Trunk line length
Drop line length
Total length of drop lines
1. I/O Message (Poll, Change of State)
2. Explicit Message
319 (Fuji Electric Group)
AC drive (code: 2)
9219
OPC-G1-DEV
AC Drive
Selectable between 4 and 8 bytes for input and output (independently)
CIP Specifications Volume 1, Edition 2.2 Japanese version and Volume
3, Edition 1.1 Japanese version
(Certified by ODVA Japan for Conformance Test Version 20)
Group 2 only server
37
Specifications
(Note)
Specifications
500 kbps
250 kbps
100 m
250 m
6 m
39 m
78 m
125 kbps
500 m
6 m
6 m
156 m

Advertisement

Table of Contents
loading

Related Products for FujiFilm OPC-G1-DEV

Table of Contents