Error Code List For Explicit Message Errors - FujiFilm OPC-G1-DEV Manual

8.3 Error Code List for Explicit Message Errors

If an explicit message sent from the master contains any error, the communications card responds to the master
with "94" in the service code and "error code" (see Table 8.1) in the data.
An error code is two bytes long, consisting of a general code and additional code. Some error codes have no
additional code and have "FF" instead.
Error code
General Additional
code code
08 FF Service not supported
0E FF Invalid attribute value
13 FF Not enough data
14 FF Attribute not supported
15 FF Too much data
16 FF Object does not exist
1F See blow. Vender specific error
02 No function code
(in writing)
03 Function code not
allowed to change
06 Not allowed to change
in running
07 Not allowed to change
with X terminal being
ON
08 Data entry range error
0F Function code data
being written
21 No function code
(in reading)
20 FF Invalid parameter
Table 8.1 Error Code List for Explicit Message Errors
Error name
Invalid service code
Attempted to change a
write-inhibited variable.
Attempted to write Byte
data to Word variable.
Access to a nonexistent
variable.
Attempted to write Word
data to Byte variable.
Access to a nonexistent
object.
Error unique to vendor
Attempted to write to a
nonexistent function code.
Attempted to write to a
read-only function code.
Attempted to write to a
function code not allowed to
change when the inverter is
running.
Attempted to write to a
function code not allowed to
change when X terminal is
ON.
Attempted to write data out
of the range.
Requested to write to a
function code being written.
Attempted to read from a
nonexistent function code.
Attempted to write a value
out of the range.
Description
Correct service code.
(Read: 0E hex, Write: 10 hex)
Check the specified variable
again.
Match the data size.
Check the specified variable
again.
Match the data size.
Correct the contents of the
Class.
See below.
Correct the function code
number specified.
Correct the function code
number specified.
Write after the inverter is
stopped.
Write after the X terminal is
turned OFF.
Write data within the range.
Request to write after
completion of the current writing
operation.
Correct the function code
number specified.
Correct the value within the
range.
33
Error recovery