At+Cchstop Stop Ssl Service; At+Cchaddr Get The Ipv4 Address; At+Cchsslcfg Set The Ssl Context - SimCom SIM7600 Series Command Manual

2.2.4 AT+CCHSTOP Stop SSL service

AT+CCHSTOP is used to stop SSL service.
AT+CCHSTOP STOP SSL service
Execute Command
AT+CCHSTOP
Defined Values
<err>

2.2.5 AT+CCHADDR Get the IPv4 address

AT+CCHADDR is used to get the IPv4 address after calling AT+CCHSTART .
AT+CCHSADDR Get the IPv4 address
Execute Command
AT+CCHADDR
Defined Values
<ip_address>

2.2.6 AT+CCHSSLCFG Set the SSL context

AT+CCHSSLCFG is used to set the SSL context which to be used in the SSL connection. It must be called
before AT+CCHOPEN and after AT+CCHSTART . The setting will be cleared after the CCHOPEN operation is
finished.
SIM7500_SIM7600_SIM7800 Series_SSL_AT Command Manual
Response
a)If stop SSL service successfully:
+CCHSTOP: 0
OK
b)If stop SSL service successfully:
OK
+CCHSTOP: 0
c)If failed:
ERROR
The result code, please refer to chapter 2.3.1
Response
+CCHADDR: < ip_address>
OK
A string parameter that identifies the IPv4 address after PDP
activated.
Smart Machine Smart Decision
13 / 36