Page 1
QUICK START GUIDE How to Set your IRwin Methane Leak Detector for 1 Point Calibration 2.2% (2.5%) - Universal Mode (for a factory set unit) Make sure your IRwin is set in Universal Mode (see the How to set your IRwin for Universal Mode quick start guide) Press followed by...
Page 2
How to Set your IRwin Methane Leak Detector for 1 Point Calibration 2.2% (2.5%) If prompted, enter the Supervisor (Advanced) password code If not prompted, go ahead to next step to select Generic and press followed by to navigate to Calibration and press to navigate to Settings and press If prompted, enter the (min) Intermediate password code...
Page 3
How to Set your IRwin Methane Leak Detector for 1 Point Calibration 2.2% (2.5%) Press to get to the drop-down menu Press on the first choice of the drop-down menu Navigate to far right drop-down menu and press to select Disabled and press Press again to view drop-down menu 3 of 5...
Page 4
How to Set your IRwin Methane Leak Detector for 1 Point Calibration 2.2% (2.5%) In Universal Low Range, use to select the second choice in the drop-down menu, press Navigate to far right drop-down menu and press to select Disabled and press Press again to view the drop-down menu In Universal Low Range, use...