Toro TRX-16 Operator's Manual page 26

Model 22974
Service Interval: Every 250 hours (more often in dirty
or dusty conditions)—Model 22974
only.
Every 500 hours (more often in dirty or dusty
conditions)—Model 22974 only.
Removing the Filters
1. Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
hydraulic lift.
2. Shut off the engine and remove the key.
3. Release the latches on the air cleaner and pull
the air-cleaner cover off the air-cleaner body
(Figure 29).
Figure 29
1. Air-cleaner body
2. Primary filter
3. Latch
4. Clean the inside of the air-cleaner cover with
compressed air.
5. Gently slide the primary filter out of the
air-cleaner body
Note:
Avoid knocking the filter into the side of
the body.
6. Remove the safety filter only if you intend to
replace it.
Important:
Do not attempt to clean the
safety filter. If the safety filter is dirty, then
the primary filter is damaged. Replace both
filters.
4. Air-cleaner cover
5. Safety filter
(Figure 29).
Servicing the Primary Filter
Inspect the primary filter for damage by looking into
the filter while shining a bright light on the outside of
the filter.
Note:
Holes in the filter appear as bright spots. If
the filter is dirty, bent, or damaged, replace it. Do not
clean the primary filter.
Servicing the Safety Filter
Replace the safety filter, never clean it.
Important:
Do not attempt to clean the safety
filter. If the safety filter is dirty, then the primary
filter is damaged. Replace both filters.
Installing the Filters
Important:
To prevent engine damage, always
operate the engine with both air filters and the
cover installed.
1. If you are installing new filters, check each filter
for shipping damage.
Note:
Do not use a damaged filter.
2. If you are replacing the safety filter, carefully
slide it into the filter body
3. Carefully slide the primary filter over the safety
filter (Figure
Note:
Ensure that the primary filter is fully
seated by pushing on its outer rim while installing
g001883
it.
Important:
area of the filter.
4. Install the air-cleaner cover with the side
indicated as up facing upward and secure the
latches (Figure
26
(Figure 29).
29).
Do not press on the soft inside
29).