Table of Contents
Advertisement
Removing the Bottom
Shield
1.
Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
hydraulic lift.
2.
Shut off the engine and remove the key.
3.
Loosen the 2 bolts securing the bottom shield
sequentially until the shield is free
Figure 22
1. Bottom shield
4.
Pull the shield back and out of the machine.
5.
To install the shield before operating the
machine, slide the bottom shield into the
machine so that it rests on all 4 tabs and secure
it with the 2 bolts you loosened previously
(Figure
22).
Note:
You may need to lift up on the bottom
shield to ensure that it rests on the front tabs.
(Figure
22).
g011472
2. Bolts
Lubrication
Greasing the Machine
Service Interval: Before each use or daily (Grease
immediately after every washing.)
Grease Type: General-purpose grease.
1.
Park the machine on a level surface, engage the
parking brake, and lower the hydraulic lift.
2.
Shut off the engine and remove the key.
3.
Clean the grease fittings with a rag.
4.
Connect a grease gun to each fitting
through
Figure
5.
Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
6.
Wipe up any excess grease.
23
(Figure 23
26).
Figure 23
Figure 24
g007821
g007822
Hide quick links:
Advertisement
Table of Contents
