Toro TRX-16 Operator's Manual page 45

9. With the spark plug removed from the engine,
pour 2 tablespoons of engine oil into the
spark-plug hole.
10. Place a rag over the spark-plug hole to catch
any oil spray, then use the starter or recoil
handle to crank the engine and distribute the oil
inside the cylinder.
11. Install the spark plug, but do not install the wire
on the spark plug.
12. Charge the battery (electric-start machines
only); refer to Charging the Battery (page
13. Check and adjust the track tension; refer to
Checking and Adjusting the Track Tension (page
35).
14. Check and adjust the digging chain tension;
refer to Checking and Adjusting the Digging
Chain and Boom (page
15. Check and tighten all fasteners. Repair or
replace any part that is damaged.
16. Paint all scratched or bare metal surfaces with
paint available from your Authorized Service
Dealer.
17. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place.
18. Cover the machine to protect it and keep it clean.
32).
42).
45