Advertisement
Table of Contents
- 1 Termination Instructions
- 2 Step 1: Slip the Cover on the End of the Cable.
- 3 Step 2: Remove 2.5 CM of the Jacket.
- 4 Step 3: Remove 1.5 CM of the Foil.
- 5 Step 4: Pull Back the Pairs to Expose the Plastic Cross.
- 6 Step 8: Ensure the Foil Is Put Back Around the Pairs.
- 7 Step 9: Close the Connector to Crimp the Wires.
- Download this manual
N42i.900 termination instruction
LANmark Industry Field Terminable Plug Cat 6A
September 2017 - V1.02
Advertisement
Table of Contents
Related Manuals for Nexans N42i.900
Summary of Contents for Nexans N42i.900
- Page 1 N42i.900 termination instruction LANmark Industry Field Terminable Plug Cat 6A September 2017 - V1.02...
- Page 2 4. Pull back the pairs to expose the plastic cross. 5. Cut-off the plastic cross as close to the jacket as possible (without damaging the wires) - using flush side cutters. 2 I Nexans Cabling Solutions - Installation is to performed by qualified personnel - www.nexans.com/LANsystems - info.ncs@nexans.com...
- Page 3 10. Slide the cover over the connector (a) Install the 360° shield on the underside of the connector. and tighten-up the gland (b). 3 I Nexans Cabling Solutions - Installation is to performed by qualified personnel - www.nexans.com/LANsystems - info.ncs@nexans.com...
Need help?
Do you have a question about the N42i.900 and is the answer not in the manual?
Questions and answers