Opening And Closing The Qbox-2090 Series; Figure 5: Descrewing The Access Cover Of The Qbox-2090 Series; Figure 6: Accessing Internal Components Of The Qbox-2090 Series - Quanmax QBOX-2090 Series User Manual

5.1. Opening and Closing the QBOX-2090 Series

Before opening the QBOX-2090 Series, the system must be switched off and
disconnected from the main power supply. Also, disconnect all peripheral devices from
the QBOX-2090 Series. Before you begin, ensure that you have a clean, flat and ESD-
safe surface to work on.
For opening and closing the QBOX-2090 Series, please perform the following steps:
1. Close all applications. Shut down the system properly and disconnect the connection to the main power source.
Disconnect all peripherals.
2. The QBOX-2090 Series should lay on a flat, clean surface with the access cover facing upwards.
3.
Loosen and remove the six Phillips screws, that secure the access cover to the chassis. Retain the screws for
later use.

Figure 5: Descrewing the access cover of the QBOX-2090 Series

4. Lift the access cover up.
5. Now you have access to the internal DDR3L SO-DIMM, SATA, mPCIe and M.2 slots respectively in order to remove
or install hardware components.

Figure 6: Accessing internal components of the QBOX-2090 Series

QBOX-2090 Series - User Guide, Rev. 1.2
// 26