R82 x:panda User Manual page 28

Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
Caregiver
• Read the "User Guide" carefully before use
EN
and keep it for future reference. Incorrect
use of this product may cause serious injury
to the user
• Always use the correct lifting techniques and
aids for this purpose
• Never leave the user unattended in this
product. Ensure permanent supervision by
an adult
• Repair/replacements must only be made
using new original R82 spare parts and
fittings and carried out in accordance
with the guidelines and service intervals
prescribed by the supplier
• If there is any doubt as to the continued
safe use of your R82 product or if any
parts should fail, stop using the product
immediately and contact your local dealer
as soon as possible
• Keep a hand on the handle on the back of
the chair when adjusting the back angle.
• Information about transportation can be
found in the document "Transportation in
Motor Vehicles" supplied with the product
• Information regarding frame and seat
combinations including max. load in
combination can be found at: support.r82.
org
Environment
• Observe the surface temperature on the
product, before placing an user in it. This
goes especially for users with insensitive
skin as they cannot feel the heat. If the
surface temperature is above 41°C then
allow the product to cool before use
User
• If the user is close to the max. load limit
and/or has a lot of involuntary movements,
e.g. rocking, a larger size with a higher max.
load or a different R82 product should be
considered
• For transportation the product is suitable
for children in the weight range of 22 kg to
specified max user weight for transportation
Product
• Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children
• Ensure the stability of the product is
maintained before placing the user in it
• Use the fixlocks mounted on the product
to fasten and adjust all vests and belts.
Note the prepared slots in the hip and leg
supports intended for belt guidance.
• Postition the back vertical and tighten the
bushing up against the gasspring before
transportation.
• Inspect the product and all of its accessories
and replace any worn out parts before use
• Do not expose the piston rod to scratches
etc. It is important to use a cloth or the like,
if tools are used to adjust the gas spring
• This product is tested for resistance to
ignition at level non-ignition in accordance
with EN 1021-1, EN 1021-2 and ISO 7176-
16
• The product might lose its flame resistant
characteristics if using other than original
R82 cushions
Accessories
Head Supports
• When adjusting the head support, be careful
not to get fingers caught between back of
the chair and the head support fitting
Arm rest
• Be careful not to get fingers caught between
the chair and the armpad
• Do not carry the product by the armrests
28
support.R82.org