SECOLink KM24 Short User Manual page 7

Intruder alarm system
key LED
Backlight of the
LED is always Off ; Pre-Alarm status – the
mode On.
, Settings ,
ENT ENT ENT ENT ENT ENT ENT ENT
Events from zones
This menu is visible if the setting By zone is used for controlling the backlight of the keypad. In this menu zones work
as a trigger to turn on the backlight of LCD and/or keypad keys should be marked with "+" sign. The
mark/unmark the zone.
, Settings ,
ENT ENT ENT ENT ENT ENT ENT ENT
Entry/exit sounds
In this menu it is possible to turn off entry/exit sound countdown on certain keypads where it is not needed, for
example, in the bedroom. The
, Settings ,
ENT ENT ENT ENT ENT ENT ENT ENT
Help texts
The keypad is equipped with a special
information about how to manage the system or a problem, press the
10/02 . . 25°C 14:02
READY TO ARM
1st Floor
2nd Floor
Press the key.
Info bar (KM24G)
KM24G keypad has a two line information bar at the bottom of the LCD screen. It displays information including the
alarm memory, measured temperature by SECOLINK BP1 or BT1 wireless sensors, the statistics of
communication between SECOLINK wireless sensor and a receiver, PGM output status (On/Off), GSM signal strength,
messages from modules, and etc. The information will rotate by appearing on the LCD screen every 3 seconds if there are
more than two lines of information text. Use the
once.
10/02 . . 25°C 14:02
READY TO ARM
1st Floor
2nd Floor
Info bar is not enabled.
, Settings ,
ENT ENT ENT ENT ENT ENT ENT ENT
Alarms , Yes .
ENT ENT ENT ENT ENT ENT ENT ENT
System information
System summary, technical, distributor and installer information can be found by pressing the
keypad is displaying the main view. Choose the corresponding menu and press
10/02 . . 25°C 14:02
READY TO ARM
1st Floor
2nd Floor
Press the key.
? ? ? ? ? ? ? ?
key can be customized to match different situations that occur. Available settings: Off – the
Keypad Settings , Light & Indication
ENT ENT ENT ENT
Keypad Settings , Light & Indication
ENT ENT ENT ENT
key is used to mark/unmark the partition.
# # # # # # # # # # # # # # # #
Keypad Settings , Light & Indication
ENT ENT ENT ENT
? ? ? ? ? ? ? ?
Use this mode for premises
Arming
protection when no one will
Away
be staying inside. All zones
will be protected after
Press [ENT] to arm
arming. There will be an
Press [ ] to select mode
entry delay after using a
Press [1]..[4] to select part.
door.
The key will start to blink.
? ? ? ? ? ? ? ?
It means that a help text is
available for this menu.
Press key to read the
? ? ? ? ? ? ? ?
help text.
10/02
Interface set tings
7 Show info bar Yes
Show Alarms Yes
Show Modules Mess. No
Show WL Zone Temp. Yes
Show PGM status Yes
10/02/2015 13:12 Burglar alarm, 1st Floor
Show Tech. Info Yes
10/02/2015 13:12 Burglar alarm, 2nd Floor
Select information which
will be seen in the
information bar.
Keypad Settings ,
ENT ENT ENT ENT
System Summary
System
Summary
Press [ENT] to confirm
Press [?] for next set tings
Press the key.
ENT ENT ENT ENT
navigate. Press
key LED is steady On when the partition is secured with Pre-alarm
, , ...
ENT ENT ENT ENT
, , ...
ENT ENT ENT ENT
, , ...
ENT ENT ENT ENT
key and its backlight blinks if there is some additional information. To find
Press [CLR] to exit.
Press or key to
navigate (if there are
additional text).
key to expand/collapse the bar if it is desired to view all the information at
. . 25°C 14:02
READY TO ARM
10/02/2015 13:12 Burglar alarm, 1st Floor
10/02/2015 13:12 Burglar alarm, 2nd Floor
1st Floor
Bedroom
Living room
2nd Floor
SERIAL Reporting Enabled
GPRS Reporting Enabled
GSM signal strength
Press to expand the Press
info bar.
Interface settings , ,
ENT ENT ENT ENT
BI: 1254369872
Modules 10
0. P64 v.0.06b
1. KM24G v.3.018
Press [ENT] to confirm
2. KM24G v.3.018
Press [?] for next set tings
3. KM24G v.3.018
Press or to
to exit.
CLR CLR CLR CLR CLR CLR CLR CLR
KM24, KM24A, KM24G keypad KM24, KM24A, KM24G keypad
[ ] key LED , ,
ENT ENT ENT ENT ENT ENT ENT ENT
Events from zones ,
ENT ENT ENT ENT
Entry/Exit sounds ,
ENT ENT ENT ENT
key.
? ? ? ? ? ? ? ?
Press [ENT] to arm
Press [ ] to select mode
Press [1]..[4] to select part.
Press to exit. Arming mode Away.
CLR CLR CLR CLR CLR CLR CLR CLR
10/02
READY TO ARM
+25°C
+24°C
10/02/2015 13:12 Burglar alarm, 1st Floor
10/02/2015 13:12 Burglar alarm, 2nd Floor
to collapse the
info bar.
... Show Info Bar
ENT ENT ENT ENT
.
ENT ENT ENT ENT
System
Distributor
Summary
Press [ENT] to confirm
Press [?] for next set tings
Press for next
? ? ? ? ? ? ? ?
information menu.
Short user manual
key
.
key is used to
# # # # # # # # # # # # # # # #
, .
# # # # # # # # # # # # # # # # # # # # # # # # # # # # # # # # ENT ENT ENT ENT
, .
# # # # # # # # # # # # # # # # # # # # # # # # # # # # # # # # ENT ENT ENT ENT
Arming
Away
. . 25°C 14:02
1st Floor
2nd Floor
, Yes , Show
ENT ENT ENT ENT
key when the
? ? ? ?
Page 7