Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
1.0 ActronConnect Power Supply & Module Installation Procedures:
1.1 Power Supply Installation Procedures:
Step 1.1.1. Isolate electrical power to the air conditioner at isolator or main switchboard.
Step 1.1.2. Remove lid from indoor unit electrical panel.
Lid- Electrical
Step 1.1.3. Mount the ActronConnect power supply kit, using either of the two options below, to the base of
the electrical panel as shown below:
Option 1 (Using the 2x4mm M3 screws):
Power Supply Kit
(Pre-wired Supplied)
2x4mm M3
Mounting Screws
NOTE: Use mounting screws when holes
are existing in Electrical Panel base.
Option 2 (Using the Double Sided Tape):
Power Supply Kit
(Pre-wired Supplied)
Double Sided
Tape
4
Panel
Indoor Unit
NOTES: Use double sided tape where there are no holes in the Electrical Panel base.
Make sure that the base of the electrical panel and the power supply are
clean and free of dirt or dust in order to provide a strong tape adhesion.
"PLUG C" (RJ45 Data) & Cable
to ActronConnect Module
Ensure that the earth ring terminal is pointing towards
the right side (
looking at the electrical panel
Ensure the power supply ventilation
holes are NOT covered by the excess
cables or other foreign matter.
"PLUG C" (RJ45 Data) & Cable
to ActronConnect Module
Ensure that the earth ring terminal is pointing towards
the right side (
looking at the electrical panel
Ensure the power supply ventilation
holes are NOT covered by the excess
cables or other foreign matter.
ActronConnect Installation & Commissioning Guide - Website
)
)
Doc. No.9590-1001 Version No.3.0 150901C
Hide quick links:
Advertisement
Table of Contents
