Load Paper - Epson WF-C5210 Instructions

3
Shake an ink pack 10 times, then remove it from the
packaging.
Note: Do not touch the green chip on the ink pack.
4
Move the handle forward, place the ink pack into the ink
pack tray until it clicks, then move the handle back to its
original position
.
Note: Make sure the ink pack is fully
inserted and level with the top of the
ink pack tray.
5
Insert the ink pack tray into the printer. Repeat steps 2 to
5 for the other ink packs.
Note: The ink packs are keyed to fit into the correct color slot.
If you cannot insert the ink pack tray all the way, do not force
it. Make sure the ink pack color matches the color slot on the
printer.
6
Close the ink pack tray cover and lock it.
7
Press OK on the LCD screen to start charging the ink.
Ink charging takes approximately 5 minutes. A message
appears when ink charging is complete.
4

Load paper

For instructions on loading envelopes, legal-size paper, or
using the rear paper feed slot, see the online User's Guide.
1
Make sure the product is done charging the ink, then pull
out the paper cassette.
2
Slide the side edge guides all the way out and set the
front edge guide to the paper size you are using.
3
Insert paper with the glossy or printable side down.
Note: Make sure the paper is under the arrow mark for your
paper type and loaded against the front edge of the cassette.
4
Slide the edge guides against the paper, but not too
tightly.
5
Keep the cassette flat as you insert it all the way, then pull
out the output tray extension.
6
Select the paper settings on the product's control panel.
Standard paper:
Thick paper: