Table of Contents
Advertisement
Chapter 11
4 ) In the
Remote IPSec Gateway (URL)
5 ) To configure
Site A's
In the
Tunnel access from local IP addresses
as an example. Then input the LAN IP range of Site A in the
column, and input
6 ) To configure
Site B's
In the
Tunnel access from local IP addresses
as an example. Then input the LAN IP range of Site B in the
column, and input
7 ) Select the
Key Exchange Method
8 ) Enter the
Pre-Shared Key
enabled.
Note:
Make sure Site A and Site B use the same key.
9 ) Leave the
Advanced
3 Configure on Site B (remote network). Refer to step 2 configuration on Site A and
make sure that Site A and Site B use the same
Secrecy
settings.
4 The
Status
column will change to
successfully.
5 Check the VPN connection. You can ping site B' LAN IP from your computer to verify
that the IPSec VPN connection is set up correctly.
To check the VPN connection, you can do the following.
a . On the host in Site A, press
and hit OK.
b . In the CLI window, type in "ping 192.168.2.x" ("192.168.2.x" can be IP address of any
host in Site B). Then press [Enter].
column, Enter Site B's WAN IP address.
LAN:
Subnet Mask
of Site A.
LAN:
Subnet Mask
of Site B.
for the policy. We select
for IKE authentication. Then keep
Settings as default value. Then click Save.
Up
[Windows Logo]
Specify Your Network Settings
column, here we take
column, here we take
Auto(IKE)
Perfect Forward Secrecy
pre-shared keys
if the VPN connection has been set up
+
[R]
to open Run dialog. Input "cmd"
Subnet Address
IP Address for VPN
Subnet Address
IP Address for VPN
here.
and
Perfect Forward
63
Hide quick links:
Advertisement
Table of Contents
