Star Micronics Rainbow NX-1000C User Manual page 35

I
]
1
I
)
I
)
)
I
I
I
J
)
)
J
Reverse micro-feed: On Line and Print Pitch switches
You can also feed the paper in small increments in reverse, to return
to a higher position on the same page.
Note: With fanfold forms, do not try to return to a previous page. The
perforation may catch inside the printer.
1. Press the On Line switch to set the printer off-line.
2. Press the On Line switch again and hold it down.
3. Press the Print Pitch switch. The paper will start moving backwards in
a series of small steps. When you want to stop, release both switches.
Left margin: NLQ Type Style and Print Pitch switches
Software almost always provides commands for controlling the margins,
so you will not usually have to set them from the control panel. When
necessary, however, you can set the left margin as follows.
1. Press the On Line switch to set the printer off-line.
2. Press the NLQ Type Style switch and hold it down.
3. Press the Print Pitch switch. The print head will make a short excursion
from the left end, then start advancing from left to right in a series of
steps, each equal to one pica character width (1/10"). When the print
head reaches the desired left margin position, release both switches.
The printer will beep to indicate that the margin has been set.
Right margin: NLQ Type Style and Paper Feed switches
You can also set the right margin.
1. Press the On Line switch to set the printer off-line.
2. Press the NLQ Type Style switch and hold it down.
3. Press the Paper Feed switch. The print head will travel to the right end
of the carriage, then start advancing from right to left in a series of 1/10"
steps. When it reaches the desired right margin position, release both
switches. The printer will beep to indicate that the margin has been set.
25