Table of Contents
Advertisement
DOK-MOTOR*-ML3********-IT01-EN-P
ML3 Self-Cooled Linear Motors
2
Safety instructions
2.1
About this product
2.2
Intended use
2.3
Unintended use
Trademark right third parties
Observe the general safety notes in this chapter and the safety instructions in
this documentation. Therewith, you avoid personal danger, damage and er‐
rors.
This operating instruction must be stored and transferred in case
of sale during the complete product lifetime.
Handle all motor components carefully, in all kinds of situations.
Pay close attention to the safety notes and notes regarding the
magnetic pull of the permanent magnets on the secondary part.
Prerequisites for proper and safe use of the motors are proper transport, ap‐
propriate storage, proper assembly and connection, careful maintenance, op‐
eration and overhaul.
The motors have been designed for installation in industrial machinery. The
motors are according to the following standards and directives.
Standards
DIN EN 60034-1
Rating and performance behavior
DIN EN 60034-5
Degree of protection
Directives
2014/35/EU
Low voltage directive
The machine manufacturer must evaluate the electric and mechanic safety
as well as environmental influences in the assembled state of the machine
according to the Machine Directive 2006/42/EC and DIN EN 60204-1 (safety
of machines).
The electrical installation must comply with the protection requirements of
EMC Directive 2014/30/EU. The plant manufacturer is responsible for appro‐
priate installation (for example: physical separation of signal and power ca‐
bles, using shielded cables, ...). The EMC instructions of the converter manu‐
facturer must be observed.
Start-up is prohibited as long as the conformity with these directives is de‐
clared.
Any use of the motors outside of the specified fields of application or under
operating conditions and technical data other than those specified in this doc‐
umentation is considered to be "inappropriate use".
Direct operation on the three-phase network and in explosion-hazardous
areas (ATEX) is forbidden.
Observe the trademark rights of third parties during assembly and use of sin‐
gle components delivered from Bosch Rexroth. For any infringement of the
right, the customer is liable for the accruing damage.
Bosch Rexroth AG
19/103
Safety instructions
Advertisement
Table of Contents
