Table of Contents
Advertisement
DOK-MOTOR*-ML3********-IT01-EN-P
ML3 Self-Cooled Linear Motors
5
Transport and storage
5.1
Notes about transport (shipping) instructions
Transport by air freight
5.2
Instructions on machine transport
WARNING
Please note the safety
instructionsChapter 2.6.3 andChapter 2.6.4
The motor components (primary and secondary part) must be transported in
their original package taking classes 2K2, 2B1, 2C2, 2S1, 2M2 specified acc.
to DIN EN 60721-3-2 into account.
CAUTION
Heed the packaging and transport instructions (IATA 953)
CAUTION
●
Heed the safety notes and warnings (refer to
secondary parts and make sure that they are kept.
●
Remove the transport or assembly protection which is stuck on the
cover plate only when or after mounting into the machine.
Transport the secondary part in its original packing to the place of
assembly and let it be packed until it must be mounted. Store the
original packing after assembly of the secondary part for further
use (e.g. re-storage or return). Observe a proper state and good
visibility of the affixed warning notes.
The MC 3motor components can be transported by hand. The mass of the
single components is 0.6 kg up to 11.6 kg, depending from their frame size.
NOTICE
Mounted components (e.g. KTY84) can contain parts
susceptible to electrical discharge (ESD).
Observe the ESD safety measures.
WARNING
Do not lift or move the primary part on the cable strand.
Bosch Rexroth AG
Transport and storage
Strong attractive forces due to permanent
magnets on the secondary part! Risk of injury
and danger of crushing body parts by mag‐
netic forces!
Possible influence of plane electronic on
board through magnet fields!
Risk of injuries and / or damage when
handling secondary parts of synchronous
linear motors!
Chapter 5.1
Never
touch
the
connection
electrostatic sensitive devices!
Material damage due to improper handling
during transport!
29/103
.
) when using
points
of
Advertisement
Table of Contents
