Service Check List - State Water Heaters SandBlaster SBD71 120 Service Handbook

Sbd71 120 through sbd85 500
Table of Contents

Advertisement

(This service checklist may be photo copied to assist with SBD service call.)
This checklist is intended to aid the Service Agent in determining that the State SBD
Water Heater has been properly installed and is operating correctly.
circumstances of each installation may vary greatly, it is not intended to be an all-
inclusive list of the problems that the Service Agent may encounter. Any item checked
"no" on this list should be thoroughly investigated and corrective action taken, if
required.
SERVICE AGENT
MODEL NUMBER
SERIAL NUMBER
GAS TYPE - CHECK ONE
NATURAL
PROPANE
I.
Check Clearances (circle answer)
A. Are exterior clearances adequate?
B. Are interior clearances adequate?
Comments:
II.
Check Makeup Air Requirements
A. Is the quantity of make-up air adequate per the National Fuel Gas Code?
Comments:
B. Is the quality of make-up air adequate?
Comments:
III.
Gas Pressure (fill in blank)
A.
Supply gas pressure
B.
Manifold gas pressure (main burner)
Comments:
IV.
Venting (check)
A.
Properly sized per the National Fuel Gas Code?
B.
Does the installation have mechanically assisted venting?
If so, is it operational?
Comments:
Technical Training Department
Ashland City, TN ©2003
SBD TANK TYPE HEATERS
SERVICE HANDBOOK
SBD SERVICE CHECKLIST
INSTALLATION DATE
SERVICE DATE
LOCATION ADDRESS
inches of W.C.
52
PHONE(
)
___ -
inches of W.C.
Because the
____
yes
no
yes
no
yes
no
yes
no
yes
no
yes
no
yes
no

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sandblaster sbd85 500

Table of Contents