Perform the following jobs:
– Unscrew sealing cover -arrow- with built-in dipstick from tank.
– Wipe off dipstick using a clean cloth.
– Screw sealing cover on until finger tight and then unscrew
again. Following this, fluid level can be checked.
The oil level must be in area of „cool" marking.
Tolerance: 2 mm above or below marking.
Note
If the fluid level is above the area specified, the excessive fluid
♦
must be extracted.
♦
If fluid level is below specified area, hydraulic system must be
checked for leaks (repair measure).
If the hydraulic system is not leaking, replenish required quan‐
♦
tity of hydraulic oil -G 002 000- .
– Screw sealing cover onto tank until finger tight.
4.52.2
Fluid at operating temperature (from ap‐
prox. 50 ℃)
Test prerequisites
•
Engine switched off
•
Front wheels in straight-ahead position
Perform the following jobs:
– Unscrew sealing cover -arrow- with built-in dipstick from tank.
– Wipe off dipstick using a clean cloth.
– Screw sealing cover on until finger tight and then unscrew
again, after which fluid level can be checked.
The oil level must be between the „cool" and the „hot" marking.
Note
♦
If the fluid level is above the area specified, the excessive fluid
must be extracted.
If fluid level is below specified area, hydraulic system must be
♦
checked for leaks (repair measure).
If the hydraulic system is not leaking, replenish required quan‐
♦
tity of hydraulic oil -G 002 000- .
– Screw sealing cover onto tank until finger tight.
Amarok 2011 ➤
Maintenance - Edition 01.2011
4. Descriptions of work
127