GAELCO ATV TRACK Operator's Manual page 51

9.13 TROUBLESHOOTING PROCEDURES
1) PROBLEM:The machine does not start when the mains switch is thrown.
CHECKS
•
Check the mains cable and its connections.
•
Check the fuses. Check the specifications are met. Check whether the fuses have
blown and that they have the correct current rating. The fault may have been caused by
an overload current.
•
Check the CPU connections
•
Check there is +5V AC in the power supply.
2) PROBLEM:There is something wrong with the screen colours and/or image.
CHECKS
•
Enter in Test Mode and adjust the monitor settings with the help of the screen test
(see Section 6.1)
3) PROBLEM:The game starts but the platform fails to move.
CHECKS
•
Check that the rider is pressing down correctly on both footrests.
•
Check the emergency stop button is not pressed.
•
Check the movement system by looking at the corresponding screen whilst in Test
Mode (see Section 6.3): if the platform moves, the problem lies in one of the footrests.
In this case, apply the procedure described in Section 9.5.2. If the game platform still
fails to move, carry out the following checks:
•
Check that the connections between the monitor casing and the game platform are not
loose and that the cables are undamaged.
•
Check that the frequency converters work properly (i.e. no error message
(see Sections 9.5.1 and 9.12)).
•
Check the DC driver (ATV-358): If the fuses have blown, it is likely that the power
transistors have short-circuited.
4) PROBLEM:The game platform moves but not in synchronism with the ATV image
on the monitor.
CHECKS
•
Enter the MOTION SYSTEM screen in Test Mode and check that the platform is at its
highest point when taking the reading position of both motors. The reading should be
0.50. If this is not the case or the platform leans to one side, check the position
potentiometer following the procedure described in Section 9.10.
•
Check that the screws (ATV-829) are properly tightened on their respective shafts.
•
Check that the plastic coupling (ATV-819) is not twisted and that it does not slip on the
sleeve which stands proud of the head of the centring screw (ATV-829).
GAELCO - ATV QUADS TRACK
51