GAELCO ATV TRACK Operator's Manual page 16

5.2 ASSEMBLING & INSTALLATION
To assemble the machine proceed as follows:
1. Take out the boxes containing the accessories.
2. Remove the metal brackets that fix each unit to its pallet.
3. Raise the leg levellers and put the units down on the floor with the help of a
ramp. Be very careful to avoid the risk of being crushed!
5. Assemble the back mudguards and the
exhaust pipes. The mudguards are
between the chassis and the exhaust
pipes, as shown in the drawing. The
screws are already installed on the
chassis, four on the bottom and one on
each side. Take out those screws and use
them to fix the assembly. Plug in the the
brake light connector.
GAELCO - ATV QUADS TRACK
16
4. Assemble the billboard on the
top of the monitor cabinet, using
a step. Do not climb on the
cabinet!
The screws that fix the billboard
are already installed on its place.
Remove those screw and use
them for fixing the billboard. Plug
the connector of the fluorescent
tube.