GAELCO ATV TRACK Operator's Manual page 40

6) Loosen the nuts which hold the damaged brake cable with the help of the two 12mm
spans, releasing the cable lever which operates the micro-switch.
7) The cables can then be lifted out of their plastic cupola by pulling them upwards.
8) Fit the new cable by following the reverse procedure, beginning by threading the cable
into the cupola from the top. Adjust the largest diameter cable holder in the cupola and then
follow the steps below:
•
Fit the end of the cable in the lever housing.
•
Fit the tensor.
•
Fit the other end of the cable to the brake lever. Bear in mind that the cables from the
cupola cross over to the opposite handlebar.
•
Close the special clamp over the cable, whilst holding the cable holder.
•
Fit the cupola.
•
Adjust the tensor.
•
Fit the control in the chassis, remembering to connect the cables.
•
Adjust the sleeve so that it does not rub against either the screws on the bearing box or
against the screws which hold the control assembly onto the chassis.
•
Fit the rubber sleeves back on the levers.
•
Fit the plastic covers back on steering assembly.
•
Ensure that both the brakes and the steering assembly are working properly by
checking the INPUT / OUTPUT screen in Test Mode.
9.4.3 CHANGING THE BRAKE MICRO-SWITCH
If the micro-switch needs changing, ensure that the cables are
connected to the square terminal and that it is a contact which
is NORMALLY CLOSED (NC). This terminal is the one closest
to the square terminal.
GAELCO - ATV QUADS TRACK
40