Appendix A: Emc Information - Respironics EverFlo User Manual

EverFlo User Manual

Appendix A: EMC Information

g m
uidance and anufacturer
electromagnetic environment specified below. The user of this device should make sure it is used in such an environment.
e t
missions est
RF.emissions
CISPR.11
RF.emissions
CISPR.11
Harmonic.emissions
IEC.61000-3-2
Voltage.fluctuations/Flicker.emissions
IEC.61000-3-3
g m
uidance and anufacturer
electromagnetic environment specified below. The user of this device should make sure it is used in such an environment.
i t
mmunity est
Electrostatic.Discharge.(ESD)
IEC.61000-4-2
Electrical.Fast.Transient/Burst
IEC.61000-4-4
Surge
IEC.61000-4-5
Voltage.dips,.short.
interruptions.and.voltage.
variations.on.power.supply.
input.lines
IEC.61000-4-11
Power.frequency.(50/60.Hz).
magnetic.field
IEC.61000-4-8
NOTE:.U .is.the.a.c..mains.voltage.prior.to.application.of.the.test.level.
T
2
' d - e
s ecLaration
c
ompLiance
Group.1
Class.B
Class.A
Complies
' d - e
s ecLaration
iec 60601 t
est
L
eveL
±6.kV.contact
±8.kV.air
±2.kV.for.power.supply.lines
±1.kV.for.input-output.lines
±1.kV.Line.to.Line
±2.kV.Line(s).to.Ground
<5%.U
T
..(>95%.dip.in.U ).for.0.5.cycle.
T
40%.U
T
..(60%.dip.in.U ).for.5.cycles
T
70%.U .
T
..(30%.dip.in.U ).for.25.cycles.
T
<5%.U .
T
..(>95%.dip.in.U ).for.5.sec
T
3.A/m
e
Lectromagnetic missions
e
Lectromagnetic
The.device.uses.RF.energy.only.for.its.internal.function..Therefore,.its.
RF.emissions.are.very.low.and.are.not.likely.to.cause.any.interference.
in.nearby.electronic.equipment.
The.device.is.suitable.for.use.in.all.establishments,.including.
domestic.establishments.and.those.directly.connected.to.the.public.
low-voltage.power.supply.network.
i
Lectromagnetic mmunity
c L
ompLiance eveL
±6.kV.contact
±8.kV.air
±2.kV.for.supply.mains
±1.kV.for.input/output.lines
±1.kV.Line.to.Line
±2.kV.Line(s).to.Ground
<5%.U
T
..(>95%.dip.in.U ).for.0.5.cycle.
T
40%.U
T
..(60%.dip.in.U ).for.5.cycles
T
70%.U .
T
..(30%.dip.in.U ).for.25.cycles
T
<5%.U .
T
..(>95%.dip.in.U ).for.5.sec
T
3.A/m
:
This device is intended for use in the
e - g
nvironment uidance
:
This device is intended for use in the
e e
Lectromagnetic nvironment
g
uidance
Floors.should.be.wood,.concrete.or.ceramic.
tile..If.floors.are.covered.with.synthetic.
material,.the.relative.humidity.should.be.at.
least.30%.
Mains.power.quality.should.be.that.of.a.
typical.home.or.hospital.environment.
Mains.power.quality.should.be.that.of.a.
typical.home.or.hospital.environment.
Mains.power.quality.should.be.that.of.a.
typical.home.or.hospital.environment..If.
the.user.of.the.device.requires.continued.
operation.during.power.mains.interruptions,.
it.is.recommended.that.the.device.be.
powered.from.an.uninterruptible.power.
supply.or.a.battery.
Power.frequency.magnetic.fields.should.be.
at.levels.characteristic.of.a.typical.location.in.
a.typical.hospital.or.home.environment.
-