Displaying And Maintaining Mld Snooping - H3C S5500-EI Series Operation Manual

Operation Manual – Multicast
H3C S5500-EI Series Ethernet Switches
II. Configuring IPv6 multicast group replacement on a port or a group of ports
Follow these steps to configure IPv6 multicast group replacement on a port or a group
of ports:
Enter system view
Enter the
corresponding
view
Configure IPv6 multicast group
replacement
Caution:
Be sure to configure the maximum number of IPv6 multicast groups allowed on a port
(refer to
before configuring IPv6 multicast group replacement. Otherwise, the IPv6 multicast
group replacement functionality will not take effect.

3.7 Displaying and Maintaining MLD Snooping

View the information about
MLD Snooping multicast
groups
View the statistics information
of MLD messages learned by
MLD Snooping
Clear MLD Snooping multicast
group information
Clear the statistics information
of all kinds of MLD messages
learned by MLD Snooping
To do...
Enter
Ethernet port
view
Enter port
group view
Configuring Maximum Multicast Groups that that Can Be Joined on a
To do...
Chapter 3 MLD Snooping Configuration
Use the command...
system-view
interface interface-type
interface-number
port-group { manual
port-group-name |
aggregation agg-id }
mld-snooping
overflow-replace [ vlan
vlan-list ]
Use the command...
display mld-snooping group
[ vlan vlan-id ] [ verbose ]
display mld-snooping
statistics
reset mld-snooping group
{ ipv6-group-address | all }
[ vlan vlan-id ]
reset mld-snooping statistics
3-21
Remarks
—
Use either
command
Required
Disabled by default
Port)
Remarks
Available in any
view
Available in any
view
Available in
user view
Available in
user view