H3C S5500-EI Series Operation Manual page 46

Operation Manual – Multicast
H3C S5500-EI Series Ethernet Switches
II. Network diagram
Source
1.1.1.1/24
Figure 2-4 Network diagram for static router port configuration
III. Configuration procedure
1) Configure the IP address of each interface
Configure an IP address and subnet mask for each interface as per
detailed configuration steps are omitted.
2) Configure Router A
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 1/0/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] igmp enable
[RouterA-GigabitEthernet1/0/1] pim dm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface GigabitEthernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim dm
[RouterA-GigabitEthernet1/0/2] quit
3) Configure Switch A
# Enable IGMP Snooping globally.
<SwitchA> system-view
[SwitchA] igmp-snooping
[SwitchA-igmp-snooping] quit
GE1/0/2 GE1/0/1
1.1.1.2/24 10.1.1.1/24
Router A
IGMP querier
Switch C
GE1/0/5
Host C
Receiver
Host B
Chapter 2 IGMP Snooping Configuration
Switch A
GE1/0/1
GE1/0/2 GE1/0/2
Host A
Receiver
2-27
Switch B
Figure 2-4. The