H3C S5500-EI Series Operation Manual page 216

Operation Manual – Multicast
H3C S5500-EI Series Ethernet Switches
II. Analysis
If a multicast forwarding boundary has been configured through the multicast
boundary command, any multicast packet will be kept from crossing the boundary.
III. Solution
1) Use the display pim routing-table command to check whether the corresponding
(S, G) entries exist on the router. If so, the router has received the multicast data;
otherwise, the router has not received the data.
2) Use the display multicast boundary command to view the multicast boundary
information on the interfaces. Use the multicast boundary command to change
the multicast forwarding boundary setting.
3) In the case of PIM-SM, use the display current-configuration command to
check the BSR and RP information.
9-18
Chapter 9 Multicast Routing and
Forwarding Configuration