H3C S5500-EI Series Operation Manual page 133

Operation Manual – Multicast
H3C S5500-EI Series Ethernet Switches
Follow these steps to configure a BSR admin-scope region boundary:
Enter system view
Enter interface view
Configure a BSR
admin-scope region
boundary
V. Configuring global C-BSR parameters
The BSR election winner advertises its own IP address and RP-set information
throughout the region it serves through bootstrap messages. The BSR floods bootstrap
messages throughout the network periodically. Any C-BSR that receives a bootstrap
message maintains the BSR state for a configurable period of time (BSR state timeout),
during which no BSR election takes place. When the BSR state times out, a new BSR
election process will be triggered among the C-BSRs.
Follow these steps to configure global C-BSR parameters:
Enter system view
Enter PIM view
Configure the Hash mask
length for RP selection
calculation
Configure the C-BSR
priority
Configure the bootstrap
interval
Configure the bootstrap
timeout time
To do...
system-view
interface interface-type
interface-number
pim bsr-boundary
To do...
system-view
pim
c-bsr hash-length
hash-length
c-bsr priority priority
c-bsr interval interval
c-bsr holdtime interval
Use the command...
Use the command...
7-24
Chapter 7 PIM Configuration
Remarks
—
—
Required
No BSR admin-scope
region boundary by
default
Remarks
—
—
Optional
30 by default
Optional
0 by default
Optional
For the system default,
see "Note" below.
Optional
For the system default,
see "Note" below.