Table of Contents
Advertisement
5-2.
Error Display
A self-diagnosis test is performed when the LED light sequentially at power on.
A self-diagnosis test is performed only, without lighting the LED when recovering from a
transport path open state, when the reset command is executed.
The result of the test is displayed by the LED and buzzer.
Test Results
Normal
SRAM error
EEPROM error
Print head lifter motor
error
Erase
head/thermistor
error
Other errors
Cover open
Transport path open
5-3.
Loading Setting Cards
The setting card loading operation is performed by turning on the power while holding down
the cleaning switch.
When the setting card is then inserted, the information on the card changes the operating
mode of the device.
If the changes are successful, success is printed at the bottom of the card. If an error occurs,
unsuccessful is printed.
Refer to the setting card application manual for details regarding the creation of a setting card.
5-4.
Self-test Operation
After setting the setting card reading operation, click on the CLEANING switch again to cause
the LED to flash in orange. This will enter the self-test mode.
In the self-test mode, the device waits for a card to be inserted, then writes test data to the
magnetic stripe after the card is inserted. The results of the test data print the internal
EEPROM setting status and the device version onto two cards, and discharges the cards.
(On LAN models, NIC REPORT plus the normal test print is printed to two cards.)
If a setting card is inserted during a self-test, the card will be discharged and the self-test
operation will be canceled.
When performing a self-test, magnetic data for the test is written to the card. Use a card
whose magnetic stripe can be overwritten without causing a problem.
After setting the setting card reading operation, a print patter is printed one card that is
different from the one above if you continue pressing the CLEANING switch until the buzzer
stops ringing.
Display
STATUS and buzzer flash one time
STATUS and buzzer flash two times while
CLEANING lights.
STATUS and buzzer flash three times while
CLEANING lights.
STATUS and buzzer flash four times while
CLEANING lights.
CLEANING and buzzer flash two times while
STATUS lights.
CLEANING and buzzer flash four times while
STATUS lights.
Buzzer intermittent ringing
Buzzer intermittent ringing and STATUS
flashing
63
Remarks
Ambient
temperature
sensor
operation
error, etc.
Advertisement
Table of Contents
