Task 2 - Run The Powervault Installation Scripts On The Archiver, Concentrator, Or (Network) Decoder - Dell PowerVault MD1400 Setup Manual

4. For the Series 6 - R640 host, you can connect two to four PowerVaults to the RAID
controller if you are encrypting the PowerVaults.
a. Connect the Primary Port 1 of the first PowerVault to Port 0 of the Decoder RAID
controller.
b. Daisy chain up to three additional PowerVaults to the first PowerVault.
The following figure shows you how to connect multiple PowerVaults to an RSA Series
6 hosts. You can attach up to four PowerVaults. You connect the first PowerVault to Port
0 of the Series 6 - R640 host and daisy-chain PowerVaults two, three, and four to the
first PowerVault.
5. When you finish the cabling, ensure that the PowerVault is powered on and then power on
the host.
Task 2 - Run the PowerVault Installation Scripts on the Archiver,
Concentrator, or (Network) Decoder
This procedure only applies to NetWitness Platform 11.2 and earlier.
Note: For NetWitness Platform 11.3 and later, refer to Storage Guide for RSA NetWitness
Platform Version 11.3 and later for instructions on how to allocate storage for your hardware.
The session commands and output in this procedure use the (Network) Decoder as an example
of the host configuration for a PowerVault with encryption.
Install PowerVault with Encryption on a Series 6 R640 Host
PowerVault (Dell MD1400) Setup Guide
34