Dell PowerVault MD1400 Setup Manual page 64

68 0 (U) 9
68 0 (U) 10 10.692 TB
68 0 (U) 11
If a drive is in a foreign state, it shows F in the State column. If a drive is in a bad state, it
shows B in the State column. A PowerVault that has never been used before should show
U for unconfigured.
a. Ensure that the number of drives listed in the results equals 12.
The following example lines from the results show the correct number of drives:
Adapter 1 (PERCH810 Adapter) enclosures found: 2
Adapter 1 (PERCH810 Adapter) enclosure 160 slots found: 12
The following example lines from the results show that there is a bad drive:
Adapter 1 (PERCH810 Adapter) enclosures found: 1
Adapter 1 (PERCH810 Adapter) enclosure 121 slots found: 11
WARNING: Physical disk problems have been found.
It is also important that all drives appear numerically in the nwraidutil output. It is
possible that a bad drive may not show up at all in the output. You will see a jump in the
Slot count. For example, if the enclosure has 12 drives, but you only see slots 0 - 11, it
means that slot 12 is bad and cannot be seen by the RAID controller. Contact RSA
Customer Support before running the script because an RMA may be necessary.
5. To run the
NwArrayConfig.py
commands.
For RSA NetWitness Platform versions 10.6.6.0 or later, run the following command:
./NwArrayConfig.py
For RSA NetWitness Platform 11.1.0.2 and later, run the following command:
OWB_ALLOW_NON_FIPS=1 ./NwArrayConfig.py
If you are not using the defaults, the following options are available:
[root@<hostname> saTools]# ./NwArrayConfig.py -h
Usage: NwArrayConfig.py [options]
Options:
-h, --help
-s SRVC, --service=SRVC
Enter the service type to use 3rd party storage with.
You will be prompted to chose a volume group to use
for each DB. (decoder | logdecoder | concentrator |
archiver)
Install PowerVault on Core Appliance Used as a Hybrid
PowerVault (Dell MD1400) Setup Guide
10.692 TB HGST HUH721212AL5200 NS018DGX2NPH
HGST HUH721212AL5200 NS018DGXZLPH
10.692 TB HGST HUH721212AL5200 NS018DGXYLZH
script using the default parameters, use one of the following
show this help message and exit
64