Restart The Service - Dell PowerVault MD1400 Setup Manual

e. Select the Decoder or Log Decoder and then select
f. Expand the database folder and select the config folder.
g. Look at the packet.dir node and expand it fully. Ensure there is an entry for the added
PowerVault and the size of the packetdb is as follows:
/var/netwitness/decoder/packetdb#=<n>
where <n> is similar to the size of the new storage.
h. Follow steps 6 e-g and verify the meta.dir node on the Concentrator.

Restart the Service

You must restart the Decoder, Log Decoder, Concentrator, or Archiver service so that the
service can recognize the new volumes.
Note: If this physical host has a Log Decoder or (Network) Decoder service which is
currently capturing, it is a best practice to stop capture before restarting these services (to
ensure database writes are completed). If this physical host has a Concentrator or Archiver
service which is aggregating, it is recommended to stop aggregation before restarting these
services (to allow the indexes in memory to be saved to disk).
1. To restart the service, run the following commands using the appropriate service name for
your service.
For RSA NetWitness Platform versions 10.6.6.0 or later:
stop <nwdecoder, nwarchiver, nwconcentrator, nwlogdecoder>
this completes.)
start <nwdecoder, nwarchiver, nwconcentrator, nwlogdecoder>
For RSA NetWitness Platform 11.1.0.2 and later:
service <nwdecoder, nwarchiver, nwconcentrator, nwlogdecoder> stop
(Wait until this completes.)
service <nwdecoder, nwarchiver, nwconcentrator, nwlogdecoder> start
2. Make sure that the service comes back online and begins capture.
a. In the NetWitness Platform Services view (Administration > Services or ADMIN >
Services), verify that the service status is green.
b. Select the service and then select
c. If you see the Start Capture or Start Aggregation icon in the toolbar, click the icon to
start it.
Install PowerVault without Encryption
PowerVault (Dell MD1400) Setup Guide
> View > System.
> View > Explore.
(Wait until
28