Dell PowerVault MD1400 Setup Manual page 27

./NwArrayConfig.py --drives <N>
For RSA NetWitness Platform versions 11.1.0.2 and later, run the following command:
OWB_ALLOW_NON_FIPS=1 ./NwArrayConfig.py --drives <N>
where is the number of drives to be assigned to the Concentrator service. By default
<N>
is . If this is a Log Decoder Hybrid for logs, RSA recommends using a value of
3
efficiently allocate the storage between the two services.
[root@P<hostname> saTools]#
This script discovers all available PowerVaults; creates all the necessary virtual drives,
logical volumes, and the directory structure; and writes the debug messages to
/opt/rsa/saTools/arrayCfg.log.
6. Verify the results:
a. Ensure that the script did not produce any errors by viewing the
/opt/rsa/saTools/arrayCfg.log file:
more /opt/rsa/saTools/arrayCfg.log
b. Run the following command to verify the new sizes of the databases:
df -hP | grep 'decoder\|concentrator\|Filesystem'
The following is an example of the results that are displayed for a Hybrid Network
Decoder:
c. Ensure that there is an entry for the added PowerVault. An individual
, and
metadb0 sessiondb0
listed for
/var/netwitness/decoder/packetdb0
extended storage arrays attached. Write this value down so that you can verify it in the
NetWitness Platform Interface.
d. Log in to RSA NetWitness Platform and go to Administration > Services or ADMIN >
Services.
The Administration Services view is displayed.
27
PowerVault (Dell MD1400) Setup Guide
is created for the added PowerVault. Verify that the size
packetdb0
is what you would expect with the
Install PowerVault without Encryption
<N>
to more
7
,