Star Micronics NB24-10/15 User Manual page 77

68
THIS LINE SPACING
IS SET TO 9
THIS LINE SPACING IS SET TO 10
THIS LINE SPACING IS SET TO 11
THIS LINE SPACING IS SET TO 12
THIS LINE SPACING IS SET TO 14
THIS LINE SPACING IS SET TO 15
THIS LINE SPACING IS SET TO 16
THIS LINE SPACING IS SET TO 17
THIS LINE SPACING IS SET TO 18
THIS LINE SPACING IS SET TO 19
THIS LINE SPACING IS SET TO 20
THIS LINE SPACING IS SET TO 21
THIS LINE SPACING IS SET TO 22
THIS LINE SPACING IS SET TO 23
THIS LINE SPACING IS SET TO 24
THIS LINE SPACING IS SET TO 25
LINE SPACING IS SET TO l/6 INCH (NORMAL).
By comparing with the results between the Standard mode
and the IBM modes, you'll notice that the (ESC) "A" CHR$(n)
command with the IBM modes defined the line spacing as n/72
of an inch, instead of n/60 of an inch.
This is because that the IBM Graphics printer and Proprinter
are normally sets the line spacing to n/72 of an inch with this
command, and most software programs use this command to set
the line spacing. And we've thought the compatibility with
those programs. In addition, the (ESC) "3" CHR$(n) command
sets the line spacing to n/216 of an inch with the same reason.
Table 5-2 shows all the line spacing commands, including
several "shortcut" commands for commonly used line spacings.