Star Micronics NB24-10/15 User Manual page 16

7
The mute cover reduces the printer's operating sounds.
Note the position of the guide pins on the mute cover as
shown in Figure l-7. Holding the mute cover at each end, insert
the guide pins into the cutout hooks on the printer cover. Hold
the mute cover down onto the printer.
To remove it, reverse the procedure.
n Installing the interface board
r
k.
i
i.
E,
I
L
cover
, Interface board
Figure 1-8.
Slide the I/F board into the slot.
A parallel interface board comes standard with your printer.
In addition, there are two optional interface (I/F) boards: a serial
interface board that lets you connect to a serial (RS-232C) com-
puter port; and the other board contains extra buffer memory
for parallel output. All three boards are installed the same way.
To install or change an I/F board, turn off the power and turn
the printer around. Notice the snap-on cover at the left end.
Take it off by sliding it upwards.
Fit the I/F board into the side slots and slide it all the way
down (don't force it). Make sure that the board connector is
seated snugly in its socket. Put the cover back on and connect
the cable from your computer - you're ready to go.
?